DB2 HDTV Antenna Bundle

Home > Antenna Bundles >

DB2 HD Antenna Bundle

This antenna bundle includes the DB2 HD Antenna, Low Noise Amplifier, 100ft coax cable and J-Mount Bracket.

Was: $156.99
Our Price: $119.95

Description

This antenna bundle includes the DB2 HD Antenna, Low Noise Amplifier, 100ft coax cable and J-Mount Bracket.

Additional Details of this product:

Included with this bundle:

DB2 HD Antenna
PA-18 UHF/VHF Antenna Low Noise Pre-Amplifier Kit
100� Coax. Cable
J-Mount Bracket

DB2 Multi-Directional HDTV Antenna:

Although the DB2 was originally designed for outdoor use, it has quickly become one of our most popular indoor antennas due to its small size and extraordinary gain. The bowtie design provides strong gain across the entire UHF spectrum and it functions incredibly well in areas where a low profile antenna is required. In fact the DB2 was recently named "The highest performing indoor antenna" from HDTV Primer.

Range: 1-30 Miles
Multi-directional (pulls in signals from many directions)
Achieves a high gain of up to 11.4 dB
Ideal for UHF channels 14-69
Great for indoor, outdoor, and attic use
Dimensions 12" H x 19" W x 4" Deep
Weight: 2.8 pounds
Lifetime Warranty
Assembly Instructions

PA-18 UHF/VHF Antenna Low Noise Pre-Amplifier Kit:

The PA-18 is an ultra low noise, mast mounted pre-amp system that provides a gain of 15 db and a 2.8 dB maximum noise figure. The PA-18 offers overload resistance, a scatter filter and superior RF shielding.

Features:

18.6 dB VHF/15.4 dB UHF gain
75 ohm F connector input
75 ohm F connector output
1.8 dB noise figure
All weather design
Kit includes power inserter and 2 coax cables
Frequency range 40-862 MHz

Antenna Amplifier Installation

Antenna Amplifiers will perform best when connected properly. Remember an amplifier cannot create a signal. It will help over come the loss caused from cable runs and splitters.

A pre amp will work best when it is amplifying the signal at its strongest point; nearest the antenna.

Connect the antenna's transformer to the pre amp "In" port as shown using the supplied 2 foot cable.
Strap the pre amp to the antenna mast using the supplied cable tie.
Run your coaxial cable down lead (not supplied) inside your building and connect to the right port of the power inserter. (Do not reverse the connection!!)
Connect the left port of the power inserter to your digital receiver using the supplied 4 foot cable (above). (Do not reverse the connection!)
Plug the inserter to an 110v power source.

ClearStream Antenna Mount:

The ClearStream� J-Mount is just like our basic J-Mount - only smaller. This 20" mast with a 1" diameter is ideally suited for our ClearStream� Antenna line. Like our basic J-Mount, the CJ Mount has a pivoting foot, which allows installation on vertical or horizontal surfaces. Mounting hardware is included.

The kit includes:

20 �J-Shaped mounting pole
Mounting bracket
Expansion bolts

Every Antennas Direct antenna includes an adjustable mounting clamp that allows for easy installation with a variety of TV antenna mounts and masts. If you need extra elevation on your antenna beyond the 3 - 4 foot length, we recommend visiting your local home improvement store for these items.

Related Products...

DB4 HDTV Antenna Bundle

Our Price: $129.95
Add

ClearStream 2 Bundle with FREE Signal Meter

Our Price: $99.95
Add

DB8 HDTV Antenna Bundle

Our Price: $174.95
Add

ClearStream 4 Antenna Bundle

Our Price: $214.95
Add

ClearStream 1 Antenna Bundle

Our Price: $159.95
Add

The Largest HDTV Antenna superstore specializing in Digital TV Antenna, Outdoor HD Antenna and Indoor HD Antenna