 |
 |
 |
|
| This antenna bundle includes the DB4 HDTV Antenna, Low Noise Amplifier, 100ft coax cable and J-Mount Bracket. |
|
|
|
|
|
 |
|
 |
|
Additional Details of this product:
Included with this bundle:
- DB2 Multi-Directional HDTV Antenna
- PA-18 UHF/VHF Antenna Low Noise Pre-Amplifier Kit
- 100’ Coax. Cable
- J-Mount Bracket
DB4 Multi-Directional HDTV Antenna:
The DB4 has become our most popular model because it is simply the best Mid Range HDTV antenna on the market. With an approximate 13.7 dB gain, it is one of the strongest multi-directional antennas available and performs consistently across the entire UHF spectrum. It even works well in areas where HD transmitters are in multiple directions.
The bow tie design of the DB4 uses triangular elements instead of rods to greatly increase the bandwidth allowing it to cover the entire UHF band. Additionally, the mesh reflector of the bowtie is more efficient than a rod reflector, is lower in weight, and provides less wind resistance for greater performance and durability.
If you are looking for an antenna that is practically guaranteed to perform, the DB4 is one of your safest choices. It will pull in all UHF frequencies and most higher level VHF frequencies with a range of about 55 miles.
- Range: Up to 55 miles
- Strong performance across UHF spectrum (Channels 14-69)
- Versatile high gain multi - bay antenna
- Efficient design allows tremendous gain in a compact size
- 13.7 dB gain
- Versatile HD antenna, succeeds in difficultareas where other antennas fail
- All weather Balun included
- Designed to resist extreme wind loading
- Works great in attics. Fits easily & high gain can help overcome loss from roofing materials
- Dimensions 29" H x 19" W x 4" Deep
- Weight: 4.5 pounds
- Lifetime Warranty
- Assembly Instructions
PA-18 UHF/VHF Antenna Low Noise Pre-Amplifier Kit:
The PA-18 is an ultra low noise, mast mounted pre-amp system that provides a gain of 15 db and a 2.8 dB maximum noise figure. The PA-18 offers overload resistance, a scatter filter and superior RF shielding.
Features:
- 18.6 dB VHF/15.4 dB UHF gain
- 75 ohm F connector input
- 75 ohm F connector output
- 1.8 dB noise figure
- All weather design
- Kit includes power inserter and 2 coax cables
- Frequency range 40-862 MHz
Antenna Amplifier Installation
Antenna Amplifiers will perform best when
connected properly. Remember an amplifier cannot create a
signal. It will help over come the loss caused from cable
runs and splitters.
A pre amp will work best when it
is amplifying the signal at its strongest point; nearest
the antenna.
 Connect
the antenna's transformer to the pre amp "In" port
as shown using the supplied 2 foot cable. - Strap the pre amp to the antenna mast
using the supplied cable tie.
- Run your coaxial cable down lead (not
supplied) inside your building and connect to the right
port of the power inserter. (Do not reverse the
connection!!)
- Connect the left port of the power inserter
to your digital receiver using the supplied 4 foot cable
(above). (Do not reverse the connection!)
- Plug the inserter to an 110v power source.
|
|
ClearStream Antenna Mount:
The ClearStream™ J-Mount is just like our basic J-Mount - only smaller. This 20" mast with a 1" diameter is ideally suited for our ClearStream™ Antenna line. Like our basic J-Mount, the CJ Mount has a pivoting foot, which allows installation on vertical or horizontal surfaces. Mounting hardware is included.
The kit includes:
- 20 “J-Shaped mounting pole
- Mounting bracket
- Expansion bolts
Every Antennas Direct antenna includes an adjustable mounting clamp that allows for easy installation with a variety of TV antenna mounts and masts. If you need extra elevation on your antenna beyond the 3 - 4 foot length, we recommend visiting your local home improvement store for these items.
|
|
|
 |
|
 |
|
|
|
