 |
 |
 |
|
| This antenna bundle includes the DB8 HDTV Antenna, Low Noise Amplifier, 100ft coax cable and J-Mount Bracket. |
|
|
|
|
|
 |
|
 |
|
Additional Details of this product:
Included with this bundle:
- DB8 Multi-Directional HDTV Antenna
- PA-18 UHF/VHF Antenna Low Noise Pre-Amplifier Kit
- 100’ Coax. Cable
- J-Mount Bracket
DB8 Multi-Directional HDTV Antenna:
Intended for people at great distances from the transmitters, the DB8 is our most powerful multi-directional HD antenna. In fact, its 15.8 dB gain make it one of the most powerful multi-directional antennas available.
The bow tie design of the DB8 uses triangular elements instead of rods to greatly increase the bandwidth allowing it to cover the entire UHF band. Additionally, the mesh reflector of the bowtie is more efficient than a rod reflector, is lower in weight, and provides less wind resistance for greater performance and durability.
This DB8 is the ideal antenna for use in locations that can pull long range signals from various directions and offers an attractive alternative to using a directional antenna mounted on a rotator.
- Range: Up to 70 miles or more
- Impedance 300/75 ohm
- Works up to 70 miles or more from transmitters
- Very flexible aiming characteristics
- Weatherproof construction
- High gain across entire UHF band (UHF channels 14-69)
- Max Gain 15.8 dB
- Dimensions 29" H x 42" W x 4" Deep
- Weight: 10 pounds
- Lifetime Warranty
PA-18 UHF/VHF Antenna Low Noise Pre-Amplifier Kit:
The PA-18 is an ultra low noise, mast mounted pre-amp system that provides a gain of 15 db and a 2.8 dB maximum noise figure. The PA-18 offers overload resistance, a scatter filter and superior RF shielding.
Features:
- 18.6 dB VHF/15.4 dB UHF gain
- 75 ohm F connector input
- 75 ohm F connector output
- 1.8 dB noise figure
- All weather design
- Kit includes power inserter and 2 coax cables
- Frequency range 40-862 MHz
Antenna Amplifier Installation
Antenna Amplifiers will perform best when
connected properly. Remember an amplifier cannot create a
signal. It will help over come the loss caused from cable
runs and splitters.
A pre amp will work best when it
is amplifying the signal at its strongest point; nearest
the antenna.
 Connect
the antenna's transformer to the pre amp "In" port
as shown using the supplied 2 foot cable. - Strap the pre amp to the antenna mast
using the supplied cable tie.
- Run your coaxial cable down lead (not
supplied) inside your building and connect to the right
port of the power inserter. (Do not reverse the
connection!!)
- Connect the left port of the power inserter
to your digital receiver using the supplied 4 foot cable
(above). (Do not reverse the connection!)
- Plug the inserter to an 110v power source.
|
|
ClearStream Antenna Mount:
The ClearStream™ J-Mount is just like our basic J-Mount - only smaller. This 20" mast with a 1" diameter is ideally suited for our ClearStream™ Antenna line. Like our basic J-Mount, the CJ Mount has a pivoting foot, which allows installation on vertical or horizontal surfaces. Mounting hardware is included.
The kit includes:
- 20 “J-Shaped mounting pole
- Mounting bracket
- Expansion bolts
Every Antennas Direct antenna includes an adjustable mounting clamp that allows for easy installation with a variety of TV antenna mounts and masts. If you need extra elevation on your antenna beyond the 3 - 4 foot length, we recommend visiting your local home improvement store for these items.
|
|
|
 |
|
 |
|
|
|
